Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual page 711

Chapter 32 Configuring Network Security with ACLs
Table 32-2 Commands for Displaying Access Lists and Access Groups (continued)
Command
show ip interface interface-id
show running-config [interface interface-id]
show mac access-group [interface interface-id]
You can also display information about VLAN access maps or VLAN filters. Use the privileged EXEC
commands in
Table 32-3 Commands for Displaying VLAN Map Information
Command
show vlan access-map [mapname]
show vlan filter [access-map name | vlan vlan-id]
OL-8550-02
Purpose
Display detailed configuration and status of an interface. If IP is enabled
on the interface and ACLs have been applied by using the ip access-group
interface configuration command, the access groups are included in the
display.
Displays the contents of the configuration file for the switch or the
specified interface, including all configured MAC and IP access lists and
which access groups are applied to an interface.
Displays MAC access lists applied to all Layer 2 interfaces or the specified
Layer 2 interface.
Table 32-3 to display VLAN map information.
Purpose
Show information about all VLAN access maps or the
specified access map.
Show information about all VLAN filters or about a specified
VLAN or VLAN access map.
Catalyst 3750 Switch Software Configuration Guide
Displaying IPv4 ACL Configuration
32-41