Scheduling A Reload Of The Software Image - Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual

Scheduling a Reload of the Software Image

Table 3-4
Table 3-4 Environment Variables
Variable Boot Loader Command
BOOT set BOOT filesystem:/file-url ...
A semicolon-separated list of executable files to
try to load and execute when automatically
booting. If the BOOT environment variable is not
set, the system attempts to load and execute the
first executable image it can find by using a
recursive, depth-first search through the flash file
system. If the BOOT variable is set but the
specified images cannot be loaded, the system
attempts to boot the first bootable file that it can
find in the flash file system.
MANUAL_BOOT set MANUAL_BOOT yes
Decides whether the switch automatically or
manually boots.
Valid values are 1, yes, 0, and no. If it is set to no
or 0, the boot loader attempts to automatically
boot the system. If it is set to anything else, you
must manually boot the switch from the boot
loader mode.
CONFIG_FILE set CONFIG_FILE flash:/file-url
Changes the filename that Cisco IOS uses to read
and write a nonvolatile copy of the system
configuration.
SWITCH_NUMBER set SWITCH_NUMBER stack-member-number
Changes the member number of a stack member.
SWITCH_PRIORITY set SWITCH_PRIORITY
stack-member-number
Changes the priority value of a stack member.
Scheduling a Reload of the Software Image
You can schedule a reload of the software image to occur on the switch at a later time (for example, late
at night or during the weekend when the switch is used less), or you can synchronize a reload
network-wide (for example, to perform a software upgrade on all switches in the network).
A scheduled reload must take place within approximately 24 days.
Note
Catalyst 3750 Switch Software Configuration Guide
3-16
describes the function of the most common environment variables.
Chapter 3 Assigning the Switch IP Address and Default Gateway
Cisco IOS Global Configuration Command
boot system {filesystem:/file-url ...| switch
{number | all}}
Specifies the Cisco IOS image to load during the
next boot cycle and the stack members on which
the image is loaded. This command changes the
setting of the BOOT environment variable.
boot manual
Enables manually booting the switch during the
next boot cycle and changes the setting of the
MANUAL_BOOT environment variable.
The next time you reboot the system, the switch is
in boot loader mode. To boot the system, use the
boot flash:filesystem:/file-url boot loader
command, and specify the name of the bootable
image.
boot config-file flash:/file-url
Specifies the filename that Cisco IOS uses to read
and write a nonvolatile copy of the system
configuration. This command changes the
CONFIG_FILE environment variable.
switch current-stack-member-number renumber
new-stack-member-number
Changes the member number of a stack member.
switch stack-member-number priority
priority-number
Changes the priority value of a stack member.
OL-8550-02