Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual page 666

Configuring SNMP
Though visible in the command-line help strings, the cpu [threshold] keyword is not supported. To
Note
enable the sending of SNMP inform notifications, use the snmp-server enable traps global
configuration command combined with the snmp-server host host-addr informs global configuration
command.
You can use the snmp-server host global configuration command to a specific host to receive the
notification types listed in
Beginning in privileged EXEC mode, follow these steps to configure the switch to send traps or informs
to a host:
Command
Step 1 configure terminal
Step 2
snmp-server engineID remote
ip-address engineid-string
Step 3 snmp-server user username
groupname {remote host [udp-port
port]} {v1 [access access-list] | v2c
[access access-list] | v3 [encrypted]
[access access-list] [auth {md5 | sha}
auth-password]}
Step 4 snmp-server group groupname {v1 |
v2c | v3 {auth | noauth | priv}} [read
readview] [write writeview] [notify
notifyview] [access access-list]
Step 5 snmp-server host host-addr
[informs | traps] [version {1 | 2c | 3
{auth | noauth | priv}}]
community-string [notification-type]
Catalyst 3750 Switch Software Configuration Guide
31-14
Table 31-5.
Purpose
Enter global configuration mode.
Specify the engine ID for the remote host.
Configure an SNMP user to be associated with the remote host created in
Step 2.
You cannot configure a remote user for an address without first
Note
configuring the engine ID for the remote host. Otherwise, you
receive an error message, and the command is not executed.
Configure an SNMP group.
Specify the recipient of an SNMP trap operation.
For host-addr, specify the name or Internet address of the host (the
•
targeted recipient).
(Optional) Enter informs to send SNMP informs to the host.
•
(Optional) Enter traps (the default) to send SNMP traps to the host.
•
• (Optional) Specify the SNMP version (1, 2c, or 3). SNMPv1 does
not support informs.
(Optional) For Version 3, select authentication level auth, noauth, or
•
priv.
Note The priv keyword is available only when the cryptographic
software image is installed.
For community-string, when version 1 or version 2c is specified,
•
enter the password-like community string sent with the notification
operation. When version 3 is specified, enter the SNMPv3 username.
• (Optional) For notification-type, use the keywords listed in
Table 31-5 on page
sent.
Chapter 31
31-12. If no type is specified, all notifications are
Configuring SNMP
OL-8550-02