Cisco 3750G - Catalyst Integrated Wireless LAN Controller Configuration Manual page 929

Chapter 36 Configuring IPv6 Unicast Routing
Beginning in privileged EXEC mode, follow these required and optional steps to configure IPv6 RIP:
Command
Step 1 configure terminal
Step 2 ipv6 router rip name
Step 3 maximum-paths number-paths
Step 4 exit
Step 5
interface interface-id
Step 6
ipv6 rip name enable
Step 7 ipv6 rip name default-information {only |
originate}
Step 8 end
Step 9 show ipv6 rip [name] [interface interface-id]
[database] [next-hops]
or
show ipv6 route [ipv6-address | ipv6-prefix/prefix
length | protocol]
Step 10
copy running-config startup-config
To disable a RIP routing process, use the no ipv6 router rip name global configuration command. To
disable the RIP routing process for an interface, use the no ipv6 rip name interface configuration
command.
This example shows how to enable the RIP routing process cisco, with a maximum of eight
equal-cost routes and enable it on an interface:
Switch(config)# ipv6 router rip cisco
Switch(config-router)# maximum-paths 8
Switch(config)# exit
Switch(config)# interface fastethernet2/0/11
Switch(config-if)# ipv6 rip cisco enable
For more information about configuring RIP routing for IPv6, see the "Implementing RIP for IPv6"
chapter in the Cisco IOS IPv6 Configuration Library at this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t13/ipv6_vgf.htm
OL-8550-02
Purpose
Enter global configuration mode.
Configure an IPv6 RIP routing process, and enter router
configuration mode for the process.
(Optional) Define the maximum number of equal-cost routes
that IPv6 RIP can support. The range is from 1 to 64, and the
default is four paths.
Return to global configuration mode.
Enter interface configuration mode, and specify the Layer 3
interface to configure.
Enable the specified IPv6 RIP routing process on the interface.
(Optional) Originate the IPv6 default route (::/0) into the RIP
routing process updates sent from the specified interface.
To avoid routing loops after the IPv6 default route (::/0)
Note
is originated from any interface, the routing process
ignores all default routes received on any interface.
only—Select to originate the default route, but suppress all
•
other routes in the updates sent on this interface.
originate—Select to originate the default route in addition
•
to all other routes in the updates sent on this interface.
Return to privileged EXEC mode.
Display information about current IPv6 RIP processes.
Display the current contents of the IPv6 routing table.
(Optional) Save your entries in the configuration file.
Catalyst 3750 Switch Software Configuration Guide
Configuring IPv6
36-19