Paired Locations In A C3000 Enclosure With A Half-Height Partner Server Blade; Removing The Blank - HP EH920A - StorageWorks Ultrium 1760 Tape Drive User Manual

Figure 5 Paired locations in a c3000 enclosure with a half-height partner server
blade
2.
Use the Shutdown command on the partner server blade to power down the partner server blade.
3. Remove the blank from the device bay. Squeeze in the release tabs (1) and pull the blank away
from the assembly (2), as illustrated in
In the following figure the partner server blade is installed in device bay 2. So, the blank has
been removed from device bay 1.
Figure 6 Removing the blank
4. Remove the connector cover on the rear of the tape blade assembly. Release the back of the cover
(1) and pull it away from the tape blade (2), as illustrated in
22
Installing an HP StorageWorks Tape Blade
Figure 6.
Figure 7.