Remove The Tape Drive; Releasing The Tape Drive; Disconnecting The Power And Sas Cables - HP EH920A - StorageWorks Ultrium 1760 Tape Drive User Manual
Hp storageworks ultrium tape blade user guide (509508-001, october 2008)
Hide thumbs
Also See for EH920A - StorageWorks Ultrium 1760 Tape Drive:
- Start here (3 pages) ,
- User manual (83 pages) ,
- Start here (2 pages)
Table of Contents
Advertisement
Remove the tape drive
1.
Press the mounting rails in towards the tape drive and slowly pull the tape drive away from the
chassis until the power and data cable become accessible.
Figure 32 Releasing the tape drive
2.
Disconnect the power and SAS cable at the rear of the tape drive.
Figure 33 Disconnecting the power and SAS cables
3.
Remove the tape drive completely and retain it for use with the replacement chassis.
4.
Put the faulty tape blade chassis into the packaging that contained the replacement item.
R
59
Tape Blade
Advertisement
Table of Contents
Troubleshooting
