Removing The Blank; Installing The Coupler Plate - HP EH920A - StorageWorks Ultrium 1760 Tape Drive User Manual

If not already installed, install a HP PCI Express Mezzanine Pass-Thru Card in mezzanine 3 connector
in the server blade. See the documentation that ships with the mezzanine card and the server blade
documentation for more information.
3.
Remove the blank from the device bay. Squeeze in the release tabs (1) and pull the blank away
from the assembly (2).
Figure 11 Removing the blank
4.
c7000 enclosures only: lnstall the supplied coupler plate. (This allows you to install a separate
device in the upper bay above the tape blade, if required.) Align the slots, as illustrated, and slide
forward to lock into place.
Figure 12 Installing the coupler plate
NOTE:
If you need to return the tape blade for service, you must first remove the coupler plate. See
"Remove the coupler plate" on page 58 for further details.
NOTE:
c3000 enclosures require a mini divider. This is supplied with the enclosure. Refer to the
documentation provided with the enclosure for installation instructions.
26
Installing an HP StorageWorks Tape Blade