Figure 28 Reconnecting the power and SAS cables to the tape drive
3.
Slide the tape drive into the tape blade chassis and push on the mounting rail handles until the tape
drive is fully inserted into the chassis, taking care not to catch any of the cables at the rear of
the tape drive.
Figure 29 Installing the tape drive
4.
Power on the partner server blade. The tape drive will run its hardware self-test, which takes about 5
seconds. If self-test passes, the green Ready LED on the tape drive flashes and then shows steady
green.
Follow normal operating procedures to work with the tape blade. Follow the step-by-step instructions
in this User Guide.
56
Replacing a tape blade chassis or tape drive