Chart Print; Machine Check - Dell 2135cn - Multifunction Color Laser Printer Troubleshooting Manual

On*
Fax Fwd Err
Print
Off
On
Prefix Dial
Off*
Prefix Dial Num 5byte
Off*
Discard Size On
Auto Reduction
On*
ECM
Off
2.4
4.8
Modem Speed 9.6
11.4
33.6*
Auto Print*
Fax Activity
No Auto Print
Print Always
Fax Transmit Print On Error*
Print Disable
Print Always*
Fax Broadcast Print On Error
Print Disable
Print Always
Fax Protocol Print On Error
Print Disable*
Country
Apply New Settings
Restart printer to apply new
settings
Diagnosis
The Diagnosis tab includes the Chart Print, Machine Check, Paper Wrinkle Check Mode, Environment Sensor Info, Developer Stir Mode, and Refresh
Mode pages.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.

Chart Print

Purpose:
To print various charts that can be used for the printer's diagnosis.
Values:
Outputs full halftone pages for yellow, magenta, cyan, and black. Also outputs pages to check the pitch. A total of five pages
Pitch Configuration Chart
are output. The chart is output to A4 or Letter size paper.
Ghost Configuration Chart Outputs a chart to check for ghost printing. One page is output. The chart is output to A4 or Letter size paper.
4 Colors Configuration Bands of yellow, magenta, cyan, and black are output with varying density. One page is output. The chart is output to A4 or
Chart Letter size paper.
MQ Chart Outputs charts to check for the binding in A4 or Letter.
Outputs a chart to check for proper alignment of the print image on the paper. One page is output. The chart is output to A4 or
Alignment Chart
Letter size paper.
PHD Refresh
Outputs a chart to check the light fatigue of the PHD unit. One page is output. The chart is output to A4 or Letter size paper.
Configuration Chart

Machine Check

Purpose:
Prints incoming faxes that failed to be forwarded when Fax Fwd Print is not selected.
Does not print incoming faxes that failed to be forwarded when Fax Fwd Print is not selected.
Sets a prefix dial number.
Does not set a prefix dial number.
Sets a prefix dial number of up to five digits. This number dials before any auto dial number is started.
Prints any excess at the bottom of a fax page without discarding it.
Discards any excess at the bottom of the page.
Automatically reduces a fax page to fit it onto the appropriate sized paper.
Enables the ECM (Error Correction Mode). To use the ECM, the remote machines must also support the ECM.
Disables the ECM.
Allows you to adjust the fax modem speed when a fax transmission or reception error occurs. The default is 33.6.
Automatically prints a fax activity report after every 50 incoming and outgoing fax communications.
Does not print a fax activity report automatically.
Prints a transmission report after every fax transmission.
Prints a transmission report only when an error occurs.
Does not print a transmission report after a fax transmission.
Prints a transmission report after every fax transmission.
Prints a transmission report only when an error occurs.
Does not print a transmission report after a fax transmission to multiple destinations.
Prints a protocol monitor report after every fax transmission.
Prints the protocol monitor report only when an error occurs.
Does not print the protocol monitor report.
Selects the country where the printer is used.
The default is United States.
After you complete the settings, press the Apply New Settings button to apply the changes.
Press the Restart printer to apply new settings button to apply the changes.