Printer Maintenance; System Settings - Dell 2135cn - Multifunction Color Laser Printer Troubleshooting Manual

Country Displays the country where the printer is used.
Printer Maintenance
The Printer Maintenance tab includes the System Settings, Clock Settings, Paper Density, Registration Adjustment, Adjust Altitude, Reset Defaults, Non-
Dell Toner, Initialize PrintMeter, Web Link Customization, TCP/IP Settings, Tray Settings, EWS, Scan Defaults, Fax Defaults, Copy Defaults, and Fax
Settings pages.
NOTE: Values marked by an asterisk (*) are the factory default menu settings.

System Settings

Purpose:
To configure the printer's power management, auto clear time, alarm tones, time-out time, mm/inch setting, job log auto print, position of the Print ID, setting
of the dump print, setting of the additional memory, setting of the substitute sheet, and operator panel language settings.
Values:
Power Saver Timer
Mode 1*1
Power Saver
Timer Mode
Power Saver Timer
Mode 2*1
Auto Reset
Alert Tone
5-60 minutes
Specifies the time before the printer enters the power saver timer mode 1(sleep
mode) after it finishes a job.
5 minutes*
1-6 minutes
Specifies the time before the printer enters the power saver timer mode 2 (deep
sleep mode) after it finishes a job.
6 minutes*
45 seconds*
1 minute
Specifies the time before the printer automatically resets the settings on the
2 minutes
operator panel to the defaults when no additional settings are made.
3 minutes
4 minutes
Low
Medium Emits a tone at the specified volume when the operator panel input is correct.
Panel Select
Tone
High
Off* Does not emit a tone when the operator panel input is correct.
Low
Medium Emits a tone at the specified volume when the operator panel input is incorrect.
Panel Alert
Tone
High
Off* Does not emit a tone when the operator panel input is incorrect.
Low
Medium* Emits a tone at the specified volume when the printer becomes ready.
Machine Ready
Tone
High
Off Does not emit a tone when the printer becomes ready.
Low
Medium* Emits a tone at the specified volume when copying is complete.
Copy Job Tone
High
Off Does not emit a tone when copying is complete.
Low
Emits a tone at the specified volume when any other job except copying is
Medium*
Non-Copy Job
complete.
Tone
High
Off Does not emit a tone when any other job except copying is complete.
Low
Medium* Emits a tone at the specified volume when a job ends abnormally.
Fault Tone
High
Off Does not emit a tone when a job ends abnormally.
Low
Medium* Emits a tone at the specified volume when a problem occurs.
Alert Tone
High
Off Does not emit a tone when a problem occurs.
Low
Medium* Emits a tone at the specified volume when the printer runs out of paper.
Out of Paper
Tone
High
Off Does not emit a tone when the printer runs out of paper.
Low