Displaying The Spanning-Tree Status - Cisco 2950 - Catalyst Switch Configuration Manual

Displaying the Spanning-Tree Status

Displaying the Spanning-Tree Status
To display the spanning-tree status, use one or more of the privileged EXEC commands in
Table 14-6 Commands for Displaying Spanning-Tree Status
Command
show spanning-tree active
show spanning-tree detail
show spanning-tree interface interface-id
show spanning-tree summary [totals]
You can clear spanning-tree counters by using the clear spanning-tree [interface interface-id]
privileged EXEC command.
For information about other keywords for the show spanning-tree privileged EXEC command, refer to
the command reference for this release.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
14-24
Purpose
Displays spanning-tree information on active interfaces only.
Displays a detailed summary of interface information.
Displays spanning-tree information for the specified interface.
Displays a summary of port states or displays the total lines of the STP state
section.
Chapter 14 Configuring STP
Table 14-6:
78-11380-10