Cisco 2950 - Catalyst Switch Configuration Manual page 582

Configuring Standard QoS
Command
Step 3 mls qos trust [cos | dscp]
Step 4 end
Step 5 show mls qos interface [interface-id]
[policers]
Step 6
copy running-config startup-config
To return a port to its untrusted state, use the no mls qos trust interface configuration command.
For information on how to change the default CoS value, see the
Interface" section on page
"Configuring the CoS-to-DSCP Map" section on page
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
30-22
Purpose
Configure the port trust state.
By default, the port is not trusted.
The keywords have these meanings:
cos—Classifies ingress packets with the packet CoS values. For
tagged IP packets, the DSCP value of the packet is modified based
on the CoS-to-DSCP map. The egress queue assigned to the packet
is based on the packet CoS value.
dscp—Classifies ingress packets with packet DSCP values. For
non-IP packets, the packet CoS value is set to 0 for tagged packets;
the default port CoS is used for untagged packets. Internally, the
switch modifies the CoS value by using the DSCP-to-CoS map. This
keyword is available only if your switch is running the EI.
In software releases earlier than Cisco IOS
Note
Release 12.1(11)EA1, the mls qos trust command is
available only when the switch is running the EI.
Use the cos keyword if your network is composed of Ethernet LANs.
Use the dscp keyword if your network is not composed of only
Ethernet LANs and if you are familiar with sophisticated QoS
features and implementations.
For more information about this command, refer to the command
reference for this release.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
30-23. For information on how to configure the CoS-to-DSCP map, see the
Chapter 30
"Configuring the CoS Value for an
30-35.
Configuring QoS
78-11380-10