Configuring Cpe Toggle; Configuring Syslog Export - Cisco 2950 - Catalyst Switch Configuration Manual

Configuring LRE Ports
Command
Step 3 end
Step 4
show controllers lre status psd
show controllers lre cpe version
Step 5
copy running-config startup-config
To return the switch to its default setting, use the no lre upbo {noise-model | offset value} global
configuration command.

Configuring CPE Toggle

The CPE toggle feature is enabled by default. It cannot be disabled on a link from a Cisco 575 LRE or
Cisco 576 LRE 997 CPE to a remote Ethernet device (such as PC).
You can disable CPE toggle on a Cisco 585 LRE CPE link. Then the CPE Ethernet link does not
transition to the up state when the LRE link comes up.
Beginning in privileged EXEC mode, follow these steps to disable CPE toggle on a Cisco 585 LRE CPE
link:
Command
Step 1
configure terminal
Step 2 interface interface-id
Step 3 no cpe toggle [port port-id]
Step 4
end
Step 5
show running-config
Step 6 copy running-config startup-config
To re-enable CPE toggle on the Cisco 585 LRE CPE link, use the cpe toggle [port port-id] interface
configuration command.

Configuring Syslog Export

If the syslog export feature is enabled, the switch sends the debugging messages to the LRE message
logging process and to the system message logging process.
Before enabling this feature, follow these guidelines:
•
•
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
13-22
Make sure that LRE logging is enabled.
Make sure that the console severity in the system message logging configuration is set to debugging.
For more information, see
Purpose
Return to privileged EXEC mode.
Verify the change.
Displays the LRE binary version running on the CPE.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the LRE port to be configured, and enter interface
configuration mode.
Disable CPE toggle on a CPE Ethernet link.
(Optional) Specify the CPE port on which CPE toggle is disabled.
Return to privileged EXEC mode.
Verify the change.
(Optional) Save your entries in the configuration file.
Chapter 27, "Configuring System Message Logging."
Chapter 13 Configuring LRE
78-11380-10