Cisco 2950 - Catalyst Switch Configuration Manual page 252

Configuring Ethernet Interfaces
Setting the Interface Speed and Duplex Parameters on a Non-LRE Switch Port
Beginning in privileged EXEC mode, follow these steps to set the speed and duplex mode for a physical
interface on a non-LRE switch:
Command
Step 1
configure terminal
Step 2 interface interface-id
Step 3 speed {10 | 100 | 1000 | auto| nonegotiate} Enter the appropriate speed parameter for the interface, or enter auto
Step 4
duplex {auto | full | half}
Step 5 end
Step 6
show interfaces interface-id
Step 7
copy running-config startup-config
Use the no speed and no duplex interface configuration commands to return the interface to the default
speed and duplex settings (autonegotiate). To return all interface settings to the defaults, use the default
interface interface-id interface configuration command.
This example shows how to set the interface speed to 10 Mbps and the duplex mode to half on a port:
Switch# configure terminal
Switch(config)# interface fastethernet0/3
Switch(config-if)# speed 10
Switch(config-if)# duplex half
Switch(config)# end
Setting the Interface Speed and Duplex Parameters on an LRE Switch Port
Beginning in privileged EXEC mode, follow these steps to set the speed and duplex mode for an LRE
interface on an LRE switch:
Command
Step 1
configure terminal
Step 2
interface interface-id
Step 3
local speed {10 | 100}
Step 4 local duplex {full | half}
Step 5
end
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
11-12
Purpose
Enter global configuration mode.
Enter interface configuration mode and the physical interface
identification.
or nonegotiate.
The 1000 keyword is available only for 10/100/1000 Mbps
Note
ports. 100BASE-FX ports operate only at 100 Mbps.
1000BASE-SX ports and GBIC module ports operate only at
1000 Mbps. The nonegotiate keyword is available only for
1000BASE-SX, -LX, and -ZX GBIC ports.
Enter the duplex parameter for the interface. For configuration
guidelines, see the "Configuration Guidelines" section on page
Note The duplex keyword is not available on GBIC ports.
Return to privileged EXEC mode.
Display the interface speed and duplex mode configuration.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enter interface configuration mode and the physical interface
identification.
Enter the appropriate speed parameter for the interface.
Enter the duplex parameter for the interface.
Return to privileged EXEC mode.
Chapter 11 Configuring Interface Characteristics
11-10.
78-11380-10