Cisco 2950 - Catalyst Switch Configuration Manual page 81

Chapter 4 Getting Started with CMS
Table 4-1 Toolbar Buttons (continued)
Toolbar Option Icon
1
Port Settings
Smartports
Device Macros
Smartports
Port Macros
1
VLAN
Inventory
Refresh
Front Panel
Topology
Topology
Options
Save Topology
2
Layout
Legend
Help for Active
Window
1. Not available in read-only mode. For more information about the read-only and read-write access modes, see the
2. Some options from this menu option are not available in read-only mode.
•
78-11380-10
Task
Display and configure port parameters on a switch.
Display or configure Smartports macros on a switch.
Display or configure Smartports macros on a port.
Display VLAN membership, assign ports to VLANs, and change the administration mode.
Display the device type, the software version, the IP address, and other information about a switch.
Update the views with the latest status.
Display the Front Panel view.
Display the Topology view.
Select the information to be displayed in the Topology view.
Save your arrangement of the cluster icons in the Topology view to Flash memory.
Display the legend that describes the icons, labels, and links.
Display the help for the active, open window. You can also click Help from the active window or
press the F1 key.
The feature bar shows the features available for the devices in your cluster. By default, the feature
bar is in standard mode. In this mode, the feature bar is always visible, and you can reduce or
increase the width of the feature bar. In autohide mode, the feature bar appears only when you move
the cursor to the left edge of the CMS workspace.
To enable the feature bar, click CMS > Feature Bar, and select Standard Mode.
–
To hide the feature bar, click CMS > Feature Bar, and select Autohide Mode.
–
Figure 4-2 shows the features available in a sample cluster.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Understanding CMS
"Privilege Levels" section on page
4-3
4-7.