Cisco 2950 - Catalyst Switch Configuration Manual page 531

Chapter 28 Configuring SNMP
Command
Step 3 snmp-server user username
groupname {remote host [udp-port
port]} {v1 [access access-list] | v2c
[access access-list] | v3 [encrypted]
[access access-list] [auth {md5 | sha}
auth-password]}
Step 4
snmp-server group [groupname {v1 |
v2c | v3 {auth | noauth | priv}}] [read
readview] [write writeview] [notify
notifyview] [access access-list]
Step 5
snmp-server host host-addr
[traps | informs] [version {1 | 2c | 3
{auth | noauth | priv}}]
community-string [notification-type]
Step 6 snmp-server enable traps
notification-types
Step 7 snmp-server trap-source interface-id
Step 8 snmp-server queue-length length
Step 9 snmp-server trap-timeout seconds
Step 10
end
Step 11
show running-config
Step 12
copy running-config startup-config
78-11380-10
Purpose
Configure an SNMP user to be associated with the remote host created in
Step 2.
Note You cannot configure a remote user for an address without first
configuring the engine ID for the remote host. Otherwise, you
receive an error message, and the command is not executed.
Configure an SNMP group.
Specify the recipient of an SNMP trap operation.
For host-addr, specify the name or Internet address of the host (the
•
targeted recipient).
(Optional) Enter traps (the default) to send SNMP traps to the host.
•
(Optional) Enter informs to send SNMP informs to the host.
•
(Optional) Specify the SNMP version (1, 2c, or 3). SNMPv1 is not
•
available with informs.
(Optional) For Version 3, select authentication level auth, noauth, or
•
priv.
The priv keyword is available only when the cryptographic
Note
software image is installed.
• For community-string, when version 1 or version 2c is specified,
enter the password-like community string sent with the notification
operation. When version 3 is specified, enter the SNMPv3 username.
(Optional) For notification-type, use the keywords listed in
•
Table 28-4 on page 28-11. If no type is specified, all notifications are
sent.
Enable the switch to send traps or informs and specify the type of
notifications to be sent. For a list of notification types, see
page 28-11, or enter this: snmp-server enable traps ?
To enable multiple types of traps, you must enter a separate snmp-server
enable traps command for each trap type.
(Optional) Specify the source interface, which provides the IP address for
the trap message. This command also sets the source IP address for
informs.
(Optional) Establish the message queue length for each trap host. The
range is 1 to 1000; the default is 10.
(Optional) Define how often to resend trap messages. The range is 1 to
1000; the default is 30 seconds.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Configuring SNMP
Table 28-4 on
28-13