Monitoring And Maintaining Cdp - Cisco 2950 - Catalyst Switch Configuration Manual

Chapter 24 Configuring CDP

Monitoring and Maintaining CDP

To monitor and maintain CDP on your device, perform one or more of these tasks, beginning in
privileged EXEC mode.
Command
clear cdp counters
clear cdp table
show cdp
show cdp entry entry-name
[protocol version]
|
show cdp interface [interface-id]
show cdp neighbors [interface-id]
[detail]
show cdp traffic
78-11380-10
Description
Reset the traffic counters to zero.
Delete the CDP table of information about neighbors.
Display global information, such as frequency of transmissions and the holdtime
for packets being sent.
Display information about a specific neighbor.
You can enter an asterisk (*) to display all CDP neighbors, or you can enter the
name of the neighbor about which you want information.
You can also limit the display to information about the protocols enabled on the
specified neighbor or information about the version of software running on the
device.
Display information about interfaces where CDP is enabled.
You can limit the display to the interface about which you want information.
Display information about neighbors, including device type, interface type and
number, holdtime settings, capabilities, platform, and port ID.
You can limit the display to neighbors on a specific type or number of interface
or expand the display to provide more detailed information.
Display CDP counters, including the number of packets sent and received and
checksum errors.
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Monitoring and Maintaining CDP
24-5