Operations Within An Mst Region; Operations Between Mst Regions - Cisco 2950 - Catalyst Switch Configuration Manual

Chapter 15 Configuring MSTP
•
For more information, see the
"Operations Between MST Regions" section on page

Operations Within an MST Region

The IST connects all the MSTP switches in a region. When the IST converges, the root of the IST
becomes the IST master (shown in
the lowest bridge ID and path cost to the CST root. The IST master also is the CST root if there is only
one region within the network. If the CST root is outside the region, one of the MSTP switches at the
boundary of the region is selected as the IST master.
When an MSTP switch initializes, it sends BPDUs claiming itself as the root of the CST and the IST
master, with both of the path costs to the CST root and to the IST master set to zero. The switch also
initializes all of its MST instances and claims to be the root for all of them. If the switch receives superior
MST root information (lower bridge ID, lower path cost, and so forth) than currently stored for the port,
it relinquishes its claim as the IST master.
During initialization, a region might have many subregions, each with its own IST master. As switches
receive superior IST information, they leave their old subregions and join the new subregion that might
contain the true IST master. Thus all subregions shrink, except for the one that contains the true IST
master.
For correct operation, all switches in the MST region must agree on the same IST master. Therefore, any two
switches in the region synchronize their port roles for an MST instance only if they converge to a common
IST master.

Operations Between MST Regions

If there are multiple regions or legacy 802.1D switches within the network, MSTP establishes and
maintains the CST, which includes all MST regions and all legacy STP switches in the network. The
MST instances combine with the IST at the boundary of the region to become the CST.
The IST connects all the MSTP switches in the region and appears as a subtree in the CST that
encompasses the entire switched domain, with the root of the subtree being the IST master. The MST
region appears as a virtual switch to adjacent STP switches and MST regions.
Figure 15-1
for region 1 (A) is also the CST root. The IST master for region 2 (B) and the IST master for region 3
(C) are the roots for their respective subtrees within the CST. The RSTP runs in all regions.
78-11380-10
All MST instances within the same region share the same protocol timers, but each MST instance
has its own topology parameters, such as root switch ID, root path cost, and so forth. By default, all
VLANs are assigned to the IST.
An MST instance is local to the region; for example, MST instance 1 in region A is independent of
MST instance 1 in region B, even if regions A and B are interconnected.
A common and internal spanning tree (CIST), which is a collection of the ISTs in each MST region,
and the common spanning tree (CST) that interconnects the MST regions and single spanning trees.
The spanning tree computed in a region appears as a subtree in the CST that encompasses the entire
switched domain. The CIST is formed as a result of the spanning-tree algorithm running between
switches that support the 802.1w, 802.1s and 802.1D protocols. The CIST inside an MST region is
the same as the CST outside a region.
shows a network with three MST regions and a legacy 802.1D switch (D). The IST master
"Operations Within an MST Region" section on page 15-3
15-3.
Figure 15-1 on page 15-4), which is the switch within the region with
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
Understanding MSTP
and the
15-3