Configuring The Switch With The Cli Setup Program; Accessing The Cli Through Express Setup; Required Equipment - Cisco IE 4010 Hardware Installation Manual

Configuring the Switch with the CLI Setup
Program
This appendix provides a command-line interface (CLI) setup procedure for a standalone switch. Before
connecting the switch to a power source, review the safety warnings in Warnings and Installation Guidelines.
This chapter contains the following sections.
•
•
•

Accessing the CLI Through Express Setup

When you first set up the switch, you should use Express Setup to enter the initial IP information. This process
enables the switch to connect to local routers and the Internet. You can then access the switch through the IP
address for additional configuration.

Required Equipment

You need this equipment to set up the switch:
• Computer with Windows 2000/Vista/2003/XP/Window7/Mac.
• A Web browser (IE, Firefox) with JavaScript enabled.
• A straight-through or crossover Category 5 Ethernet cable to connect your computer to the switch port.
Note
• A small paper clip to reach to button.
Note
Accessing the CLI Through Express Setup, on page 65
Accessing the CLI Through the Console Port, on page 70
Entering the Initial Configuration Information, on page 73
Do not use the RS232 serial console port for express setup.
Before running Express Setup, disable any pop-up blockers or proxy settings on your browser and any wireless
client running on your computer.
7
C H A P T E R
Cisco IE 4010 Switch Hardware Installation Guide
65