Aligning Design Elements; To Reverse The Sewing Direction Of Design Elements - Brother PS-300B Instruction Manual

To reverse the sewing direction of design elements (Modify-Swap
Start/End Point,
To reverse the sewing direction of the selected design elements:
1. Select one or more design elements.
A selection frame of "dashes" appears around the design element(s).
2. Do one of the following:
On the Modify drop-down menu, click Swap Start/End Point.
Click the Swap Start/End Point icon
Right-click to display the context menu, and then click Swap Start/End Point.
The start and end points of the selected design element(s) are switched.
NOTE: If no design element is selected in step 1, the sewing direction of all the design elements in the
design area is reversed.
This command will not reverse the Tack Method for the start and end points set in
on the View drop-down menu. This means the tack methods for the start and end points are
exchanged.

3-5-10. Aligning design elements

Use the commands on the Alignment sub-menu to align design elements.
To align design elements (Modify-Alignment-"sub-menu"):
1. Select one or more design elements.
A selection frame of "dashes" appears around the design element(s).
2. On the Modify drop-down menu, click Alignment. On the Alignment sub- menu, click
the desired command.
Refer to the table below for details on the sub-menu commands and their functions.
Sub-menu command
Align To Left
Align To Right
Align To Top
Align To Bottom
):
Aligns the two or more design elements on the left side of the selection
frame.
Aligns the two or more design elements on the right side of the
selection frame.
Aligns the two or more design elements on the top edge of the selection
frame.
Aligns the two or more design elements on the bottom edge of the
in the toolbar.
Function
147/164
Property