HP P2000 Reference Manual page 286

prompt yes|no|expert
Optional. Specifies an automatic response to the prompt to unmount/unpresent/unmap the source
volume before proceeding:
• yes: Allow the command to proceed.
• no: Cancel the command.
• expert: Cancel the command.
If this parameter is omitted, you must manually reply to the prompt.
destination-volume
A name for the volume to create in the destination vdisk. For volume syntax, see
page 21.
Example Copy master volume MV1 to new volume MV1copy on vdisk VD2:
# volumecopy source-volume MV1 dest-vdisk VD2 MV1copy
The source volume MUST be unmounted from all hosts prior to starting a volume
copy.
Ready to continue? yes
Success: Command completed successfully. (MV1) - The volume copy started.
# show volumes
Vdisk
---------------------------------------
VD2
VD2
---------------------------------------
Copy standard volume V1 on vdisk vd01 to new volume V1_copy on the same vdisk:
# volumecopy source-volume V1 dest-vdisk vd01 V1_copy
Info: Snap pool spV1 was created.
Info: Volume V1 was converted to a master volume.
The source volume MUST be unmounted from all hosts prior to starting a volume
copy.
Ready to continue? yes
Success: Command completed successfully. (V1) - The volume copy started.
See also • abort volumecopy
• create task
• show vdisks
• show volumecopy-status
• show volumes
286 Alphabetical list of commands
Name ... Type
MV1 ... master volume ...
MV1copy ... standard* ...
Command syntax on