Ssh Examples; Network Configuration; Sm Clp Network Targets, Properties, And Verbs; Target: Map1/Enetport1 - HP ntegrity iLO 2 MP Operation Manual

SSH Examples

The following examples show specific SSH commands.
Enable SSH Service
</>-> start /map1/sshsvc1
Disable SSH Service
</>-> stop /map1/sshsvc1

Network Configuration

Network commands enable you to display or modify network settings.

SM CLP Network Targets, Properties, and Verbs

This section describes targets, target properties, and supported verbs necessary to implement
the iLO 2 MP network configuration through SM CLP.

Target: map1/enetport1

The enetport1 target represents capabilities and management of the iLO 2 MP Ethernet port.
Table 6-41 shows enetport1 target information.
Table 6-41 enetport1 Properties
Property Name
AutoSense
PermanentAddress
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
set Sets a property to a specific value.

Target: map1/enetport1/lanendpt1

The lanendpt1 target represents the iLO 2 LAN endpoint settings.
Table 6-42 shows lanendpt1 target properties.
Table 6-42 lanedpt1 Properties
Property Name
EnabledState
MACAddress
Verbs
138 Using iLO 2 MP
Description
Specified if the iLO 2 MP AutoSense feature
is enabled. If it is disabled, iLO 2 MP
network speed is set to 10 mb/s.
Represents iLO 2 MP MAC address.
Description
Represents the iLO 2 MP LAN state.
Represents the iLO 2 MP MAC address.
Access and Values
Read/write
Boolean values accepted.
Read-only
The iLO 2 MP MAC address is formatted
as twelve hexadecimal digits
(10203040506) with each pair representing
one of the six octets of the MAC address.
Access and Values
Read-only
The following are valid values:
Enabled, Disabled
Read-only
The MAC address is formatted as twelve
hexadecimal digits (010203040506), with each
pair representing one of the six octets of the
MAC address.