Flash Test; Printer Setup; Defaults - Lexmark C750 Service Manual

5060-00x
3.
The power indicator blinks during the test. The test can be canceled anytime during the test by pressing
Return or Stop.
•
Once the test is complete, the power indicator turns on solid and a message displays.
xxxx Bad Blocks/yyyyyy Usable is displayed if fewer than 2000 bad blocks are detected. xxxx
•
indicates the number of bad blocks and yyyyyy indicates the number of usable blocks.
xxxx Bad Blocks/Replace Disk is displayed if more than 2000 bad blocks are detected. The
•
disk cannot be recovered because too many bad blocks exist on the disk.
4.
Press Go or Return or Stop to return to the Device Tests menu.

Flash Test

This test causes the file system to write and read data on the flash to test the flash.
Warning: This test destroys all data on the flash because the flash is reformatted at the end of the test.
To run the Flash Test:
1.
Select Flash Test from the Device Tests menu.
•
The power indicator blinks while the test is running.
Flash Test/Test Passed is displayed if the test passes and the power indicator turns on solid.
•
Flash Test/Test Failed is displayed if the test fails and the power indicator turns on solid.
•
2.
Press Go or Return or Stop to return to the Device Tests menu.

PRINTER SETUP

Defaults

This setting is used by the printer to determine whether US or non-US factory defaults should be selected. The
following printer settings have different US and non-US values:
Default values
Printer setting
Paper size (paper feeding sources which do not have
hardware size sensing capabilities)
Envelope size
(Envelope feeding sources which do not have hardware size
sensing capability)
Fax paper size
PCL symbol set
PPDS code page
Universal units of measure
Warning: Modification of the printer setting Defaults causes the NVRAM space to be restored to the printer's
factory settings.
3-30
Service Manual
US value Non-US value
Letter A4
10 Envelope DL Envelope
Letter A4
PC-8 PC-850
437 850
Inches Millimeters