5060-00x
ITU drive motor removal
See
"ITU drive motor, SKC" on page 7-27
1.
Remove the RIP board shield assembly. See
2.
Remove the engine board shield. See
3.
Remove the ITU drive motor mounting screws (B), disconnect cable (A), and remove the assembly.
Low voltage power supply (LVPS) removal
See
1.
Remove the rear fan cover. See
2.
Remove the fuser top duct. See
3.
Remove the LVPS screw type
4-38
Service Manual
"LVPS, 115V" on page 7-35
"Rear fan cover removal" on page
"Fuser top duct removal" on page
"121"
(A) from the rear of the printer.
for the part number.
"RIP board shield assembly removal" on page
"Engine board shield removal" on page
or
"LVPS, 220V" on page 7-35
4-71.
4-30.
for the part number.
4-8.
4-34.