Diagnostics Mode; Entering Diagnostics Mode; Exiting The Diagnostics Mode - Lexmark C752 Service Manual

Diagnostics Mode

To run the printer diagnostic tests described in this chapter, put the printer in Diagnostics Mode.
The tests display on the operator panel in the order shown:
•
Registration
•
Alignment Menu
•
Top Fine Margin Adjustment
•
Misc Tests
•
Print Tests
•
Hardware Tests
•
Duplex Tests (if installed)
•
Input Tray Tests
•
Output Bin Tests
•
Finisher Tests (if installed)
•
Base Sensor Test
•
Device Tests (if optional flash or disk installed)
•
Printer Setup
•
EP Setup
•
Error Log
•
Development Menu
•
Exit Diagnostics

Entering Diagnostics Mode

To enter the Diagnostics Mode:
1.
Turn the printer off.
2.
Press and hold the Go and Return buttons.
3.
Turn the printer on.
4.
Release the buttons when Performing Self Test is displayed.

Exiting the Diagnostics Mode

Select Exit Diagnostics to exit the Diagnostics Mode and return to normal mode.
5060-2XX
3-13
Diagnostic aids