Edge to Edge
Turn Edge to Edge printing on or off.
Cal Ref Adj
Warning: Should not be changed without specific instructions from the next level support.
EP Setup
EP Defaults
Fuser Temp
DC Charge Adjustment
Dev Bias Adj
Transfer Adjust
EP Defaults
The EP Defaults is used to restore each of the printer settings contained in the EP Setup menu to their factory
default value.
To restore the EP Setup settings to factory defaults, select Restore.
To exit the menu without restoring the settings to the factory defaults, select Do Not Restore.
Fuser Temp
Warning: Should not be changed without specific instructions from the next level support.
DC Charge Adjustment
Warning: Should not be changed without specific instructions from the next level support.
Dev Bias Adj
Warning: Should not be changed without specific instructions from the next level support.
Transfer Adjust
Warning: Should not be changed without specific instructions from the next level support.
5060-2XX
3-35
Diagnostic aids