Flash Test; Error Log; Viewing The Error Log; Clearing The Error Log - Lexmark C752 Service Manual

3.
The power indicator blinks during the test. The test can be canceled anytime during the test by pressing
Return or Stop.
•
Once the test is complete, the power indicator turns on solid and a message displays.
• xxxx Bad Blocks/yyyyyy Usable is displayed if fewer than 2000 bad blocks are detected. xxxx
indicates the number of bad blocks and yyyyyy indicates the number of usable blocks.
xxxx Bad Blocks/Replace Disk is displayed if more than 2000 bad blocks are detected. The disk
•
cannot be recovered because too many bad blocks exist on the disk.
4.
Press Go, Return, or Stop to return to the Device Tests menu.

Flash Test

This test causes the file system to write and read data on the flash to test the flash.
Warning: This test destroys all data on the flash because the flash is reformatted at the end of the test.
To run the Flash Test:
1.
Select Flash Test from the Device Tests menu.
•
The power indicator blinks while the test is running.
•
Flash Test/Test Passed is displayed if the test passes and the power indicator turns on solid.
•
Flash Test/Test Failed is displayed if the test fails and the power indicator turns on solid.
2.
Press Go, Return, or Stop to return to the Device Tests menu.

Error Log

Viewing the error log

The error log provides a history of printer errors. The error log contains the 12 most recent errors. The most
recent error appears in position 1 and the oldest error appears in position 12 (if 12 errors have occurred). If an
error occurs after the log is full, the oldest error is discarded. Identical errors in consecutive positions in the log
are entered. All 1xx, 2xx and 9xx error messages are stored in the error log. These errors are also shown in
Print Quality Pages.
To view the Error Log:
1.
Select Display Log from the Error Log menu.
The Error log is displayed on three screens as only four entries display at a time.
2.
To move to the next screen press Menu> to move forward or Menu< to move backward.
3.
Press Return or Stop to exit the Error Log.

Clearing the error log

To clear the Error Log:
1.
Select Clear Log from the Error Log menu.
2.
Select YES to clear the Error Log or NO to exit the Clear Log menu.
If YES is selected, the Empty Error Log displays on the screen.
3.
Press Return or Stop to exit the Clear Log menu.
5060-2XX
3-31
Diagnostic aids