Snmp Commands; Show Aaa Ias-Users; Snmp-Server Community - NETGEAR M4100 Series ProSAFE Reference Manual

show aaa ias-users

Use this command to display configured IAS users and their attributes. Passwords
configured are not shown in the show command output.
Format
show aaa ias-users
Mode Privileged EXEC

SNMP Commands

This section describes the commands you use to configure Simple Network Management
Protocol (SNMP) on the switch. You can configure the switch to act as an SNMP agent so
that it can communicate with SNMP managers on your network.
snmp-server
Use this command to set the name and the physical location of the switch and the
organization responsible for the network. The range for <name>, <loc> and <con> is from 1
to 31 alphanumeric characters.
Default none
Format
snmp-server {sysname <name> | location <loc> | contact <con>}
Mode Global Config

snmp-server community

Use this command to add (and name) a new SNMP community. A community <name> is a
name associated with the switch and with a set of SNMP managers that manage it with a
specified privileged level. The length of <name> can be up to 16 case-sensitive characters.
Note: Community names in the SNMP community table must be unique.
When making multiple entries using the same community name, the
first entry is kept and processed and all duplicate entries are ignored.
Default • Public and private, which you can rename.
• Default values for the remaining four community names are blank.
Format
snmp-server community <name>
Mode Global Config
M4100 Series ProSAFE Managed Switches
Management Commands
491