Setting Up Each Station - Linksys SPA9000-NA Installation And Configuration Manual

Restart System button .
b . Click the
c . When the confirmation message appears, click
d . When the Reboot OK. Go to Setup Page? message appears, click OK .
6 . To verify your progress, click the
a . USB status: Mount
b . Voice mail status: OK
c . SPA9000 Registration status: Registered
NOTE: If the SPA registration status is not Registered, trying powering off the SPA9000 and
powering it on again .
7 . Continue to the next procedure,

Setting Up Each Station

To set up each station, you need to assign a name, configure general settings, and enable voice mail
access (if applicable) .
1 . Start Internet Explorer, and then enter the IP address of the SPA9000 . Click
then click Advanced .
2 . Click PBX Status, near the top right corner of the page .
The screen lists each phone by Station Name and Extension number .
3 . Find the phone that you want to configure, and then click the hyperlink in the IP Address column .
The Telephone Configuration page appears in a separate browser window .
4 . Proceed as needed, depending on the features that you want to configure on your system:
General Settings (recommended):
Phone tab .
a . Click the
Linksys Voice System Installation and Configuration Guide
Configuring Phone Service and Voice Mail
OK . The SPA400 reboots .
Status tab, and verify the following settings:
"Setting Up Each Station" on page

Setting Up Each Station

57 .
Admin Login and
57