Connecting Optional Devices; Upgrading The Firmware For The Ip Phones - Linksys SPA9000-NA Installation And Configuration Manual

Connecting Optional Devices

Depending on the site requirements, you may need the following additional devices:
POES5 Power Adapter:
•
switch . If you have a SPA9x1 series phone and a PoE switch, you can connect the POES5 to the
phone to allow it to receive PoE .
MB100 Wall-Mount Kit:
•
system by allowing phones to be mounted on walls in hallways, sales floors, kitchens, and other
locations where desktop placement is not practical .
WBP54G:
The Wireless-G Bridge for Phone Adapters allows you to connect your IP phone to your
•
wireless network so that you can install phones in any location within range of your wireless
router . The bridge shares electrical power with the phone adapter or IP phone, so only one power
adapter is needed .

Upgrading the Firmware for the IP Phones

In this procedure, you install the firmware files that you downloaded previously (see
Firmware" on page 26) .
NOTE: You need to repeat this procedure to upgrade each phone individually .
1 . To find the IP address of the phone, complete the following tasks:
a . Press the Setup button on the phone keypad .
b . Scroll down to 9 - Network, and then press the Select soft key .
c . Make a note of the Current IP address that is displayed on the phone .
2 . Use the administration computer to install the latest firmware for this model of IP phone:
a . Extract the Zip file, and then run the executable file to upgrade the firmware .
b . When the Firmware Upgrade Warning window appears, click Continue .
Linksys Voice System Installation and Configuration Guide
Connecting the LVS Equipment
The POES5 provides an 802 .3af PoE port for connection back to a PoE
The MB100 wall-mount bracket increases the versatility of the LVS
Installing the IP Phones
"Downloading
38