Linksys SPA9000-NA Installation And Configuration Manual page 43

2 . When the password prompt appears, enter the default user name,
Then click OK .
NOTE: The user name must be entered exactly as shown: Admin . For information about
managing system access, refer to the LVS Administration Guide .
3 . Click Setup tab > Basic Setup .
4 . Enter the following settings:
Network Setup section:
Fixed IP address: Click the radio button, and then enter a valid IP address .
–
NOTE: To avoid addressing conflicts, enter an IP address that is outside the range of addresses
that are automatically assigned by your DHCP server .
IP Subnet Mask:
Enter the subnet mask for the subnetwork that the SPA400 is on .
–
Gateway IP Address:
–
Domain Name Server (DNS) Address section:
Primary DNS: Enter the IP address of the primary DNS server .
–
Secondary DNS:
Enter the IP address of the secondary DNS server .
–
NTP section:
NTP:
Enter a fully qualified name of a Network Time Protocol server, such as time .nist .gov .
–
Time Zone: Select the time zone for your region .
–
5 . Click Save Settings . The SPA400 will reboot . To reconnect to the web administration server, enter
the new IP address for the SPA400 in the browser Address bar .
Upgrading the Firmware for the SPA400
In this procedure, you install the firmware files that you downloaded previously (see
Firmware" on page 26) .
NOTE: You need to repeat this procedure to upgrade each SPA400 individually .
1 . Start Internet Explorer, and enter the IP address of the SPA400 .
NOTE: By default, the SPA400 is configured to obtain an IP Address via DHCP . You can check the
obtained IP address on the router DHCP server's client list .
Linksys Voice System Installation and Configuration Guide
Connecting the LVS Equipment
Enter the IP address of the router for this subnetwork .
Installing the SPA400
Admin, with no password .
"Downloading
42