Connecting An Ip Phone To The Switch; Performing A Factory Reset - Linksys SPA9000-NA Installation And Configuration Manual

"Connecting an IP Phone to the Switch" on page 37
•
"Connecting Optional Devices" on page 38
•

Connecting an IP Phone to the Switch

1 . Assemble the IP phone . For more information, refer to the phone user guide .
NOTE:
If you are connecting the SPA9x1 series phone that requires its own power, connect the
phone's power cord to the power port, and then connect the power adapter to an electrical
outlet .
2 . Connect the provided Ethernet network cable to the phone, and then connect the other end of
the cable to a Ethernet port on the multi-port switch .
After being connected to the switch, the IP phone reboots two to three times . Each reboot may
take up to one minute . The system automatically assigns an extension number to the phone .
When the IP phone displays the extension number, it is ready to be used for internal (station-to-
station) calls .
NOTE:
Depending on the installation site requirements, you may need an additional accessory
to achieve network connectivity . See
information .
3 . Repeat this procedure for each additional IP phone .

Performing a Factory Reset

If an IP phone has been used before, it may not register to the SPA9000 because it has the IP address
and registration information from a previous SPA9000 . To allow the auto-provisioning feature of the
SPA9000 to configure your phone for you, reset it to the factory default settings, as described below .
To reset the SPA phone other than the SPA901:
–
a . Press the Setup button on the phone keypad .
b . Press 14 - Factory Reset .
c . Press the select soft key to confirm .
d . After the phone reboots, the system automatically assigns an extension number to the phone .
To reset the SPA901 model:
–
a . Lift the receiver, and then press **** to activate the IVR .
b . When prompted, press 73738 .
c . Press 1 to confirm the factory reset . The IVR responds, "Option Successful . "
d . Replace the receiver . The phone reboots .
4 . To verify your progress, perform the following tasks:
Confirm that each phone is displaying an extension number and is registered .
–
a . To check the registration, press the
11 - Status .
b . Press
Ext1, and then press the select soft key .
c . Scroll down to
d . Verify that the status is
Confirm that you can place an internal call from an IP phone by dialing a phone extension .
–
NOTE:
You will learn how to configure your system for external calling in
"Configuring Phone Service and Voice
Linksys Voice System Installation and Configuration Guide
Connecting the LVS Equipment
"Connecting Optional Devices" on page 38
Setup button on the phone keypad .
Registered and that the Proxy is the IP address of the SPA9000 .
Mail" .
Installing the IP Phones
for additional
Chapter 5,
37