Connecting The Lvs Equipment; Connecting And Configuring The Switch; Connecting The Switch To The Router - Linksys SPA9000-NA Installation And Configuration Manual

4

Connecting the LVS Equipment

This chapter explains how to connect your equipment and upgrade the firmware . Connect the
equipment in the described order . At the end of each section, you verify that the installation is
progressing correctly .
"Connecting and Configuring the Switch" on page 28
•
"Installing the SPA9000" on page 31
•
"Installing the IP Phones" on page 36
•
"Installing the SPA400" on page 40
•

Connecting and Configuring the Switch

Before installing any LVS equipment, you need to connect the SLM224P Ethernet switch to a network
broadband router or Integrated Access Device (IAD) . (If the site is not already equipped with another
broadband router/IAD, Linksys recommends the use of the WRV200 broadband router to connect to
the access device .)
NOTE: In this guide, the Linksys SLM224P switch is used in all examples . However, various Linksys
switches can be used with LVS . Linksys recommends use of SLMxxxP, SRWxxxP and SRWxxxMP switch
product families with LVS . For more information, visit www .linksys .com . .
"Connecting the Switch to the Router" on page 28
•
"Configuring the Switch" on page 29
•

Connecting the Switch to the Router

In this procedure, you connect the switch to the router and a power source .
1 . Connect an Ethernet network cable to one of the Ethernet ports on your router . Then connect the
other end of the cable to an Ethernet port on the switch .
2 . Connect an administrative computer to an Ethernet port on the switch . The PC needs to have an
IP address on the same network as the switch, which has a default IP address of 192 .168 .1 .254 .
Linksys Voice System Installation and Configuration Guide
Connecting the LVS Equipment

Connecting and Configuring the Switch

Internet
Integrated
Access Device
Router
Administration
Computer
28