Downloading Firmware - Linksys SPA9000-NA Installation And Configuration Manual

Downloading Firmware

Before installing and configuring your system, download the latest firmware for your SPA9000,
SPA400 (if present), and SPA9xx phones .
This guide supports the following firmware releases . The installed firmware must be at least the
indicated in the table below .
Product Firmware Version
SPA9000 5 .2 .5
SPA400 1 .0 .1 .4
SPA922/942/962 5 .2 .8
SPA901 5 .1 .5
SPA921/SPA941 5 .1 .8
1 . Start Internet Explorer, and enter the following URL:
2 . From the menu at the top of the page, select
Choose a Product .
3 . Click
NOTE:
If you are visiting the site for the first time, you may be prompted to choose your location
before continuing .
Select Product Category page, choose IP PBX from the Voice over IP (VoIP) drop-down list .
4 . On the
Choose The Device page, choose SPA9000 .
5 . On the
Downloads, choose the Click Here link .
6 . Under
7 . Choose the version in the drop-down list .
8 . Under Firmware, click the link for the latest version of the firmware .
NOTE:
If you are using Windows XP Service Pack 2 (SP2) and Internet Explorer, you may see the
"Pop-up blocked" message in your browser information bar . If you see this message, click the
information bar and select Temporarily Allow Pop-ups . Then click the link again .
9 . Click Save in the File Download dialog box that appears .
10 . In the Save As dialog box, choose a location for the file and then click Save .
11 . When the download is complete, if prompted, click
NOTE: The name of the file depends on the firmware file of your device . If the firmware file you
download is in zip format, double-click the file and extract its contents to a single folder or to the
desktop . To extract the firmware file from the archive, use a utility such as WinZip, or use the built-
in decompression features of Windows XP .
Linksys Voice System Installation and Configuration Guide
Downloading Firmware
http://www .linksys .com
Support > Technical Support .
Close .
Preparation
26