HP A7533A - Brocade 4Gb SAN Switch Base Administrator's Manual page 488

To view zoning configurations:
Enter the cfgShow command to view the zoning configuration.
•
switch:admin cfgShow
Default Zone: OFF
Safe Zone: OFF
Defined configuration:
cfg:
zone:
zone:
[output truncated]
...
Effective configuration:
cfg:
zone:
zone:
To save the effective zone configuration to the defined database:
The defined database is not synchronized between Brocade switches in McDATA Fabric mode. When you
create a zone configuration on one switch, the new configuration is not synchronized to the defined
database. You must save the configuration to synchronize it to the defined database.
• Enter the cfgsaveactivetodefined command.
switch:admin> cfgsaveactivetodefined
You are about to save the Defined zoning configuration. This
action will save the effective configuration to the defined
configuration.
Do you want the Effective zoning to become the Defined
zoning?
Attempting to save new config to the defined config...
2sw0 Updating flash ...
...
[output truncated]
...
Attempting to save config to the defined config...
2sw0 Updating flash ...
Updating flash ...
488 Implementing an interoperable fabric
switch set
switch1; sqitch2; switch3; switch4
switch1
dd:dd:dd:dd:aa:aa:aa:aa; bb:bb:bb:cc:cc:cd:dd:dd
switch2 23:34:87:23:50:72:35:07; 12,64
switch set
switch1
dd:dd:dd:dd:aa:aa:aa:aa
bb:bb:bb:cc:cc:cd:dd:dd
switch2 23:34:87:23:50:72:35:07
12,64
[output truncated]
(yes, y, no, n): [no] yes