Epson AcuLaser C3900N Reference Manual page 51

Setting the Address Manually
You may also manually change the printer's IP address, subnet mask, and gateway by using the
following instructions. (See Chapter 3 "Understanding the Ethernet Configuration Menus" on page
41 for more information.)
Note:
When manually setting the IP address, turn off DHCP, BOOTP and ARP/PING first. In addition, when
the IP address is changed, add a new port or reinstall the printer driver.
Caution:
c
You should always notify your network's administrator before changing the printer's IP address.
1. Turn on your PC and printer.
2. When the printer's message window displays READY, press the Menu/Select key.
3. Select INTERFACE MENU, and then press the Menu/Select key.
4. Select ETHERNET, and then press the Menu/Select key.
5. Press the Menu/Select key twice and confirm that TCP/IP is set to ENABLE.
6. Select IP ADDRESS, and then press the Menu/Select key.
7. Press the and
key to save the setting.
8. Select SUBNET MASK, and then press the Menu/Select key.
9. Press the and
Select key to save the setting.
10. Select DEFAULT GATEWAY, and then press the Menu/Select key.
11. Press the and
key to save the setting.
12. Press the Cancel key 4 times to save your configuration changes. The printer is ready for printing
again.
13. When the printer's message window displays READY, press the Menu/Select key.
and and keys to set the IP address, and then press the Menu/Select
and and keys to set the subnet mask, and then press the Menu/
and and keys to set the gateway, and then press the Menu/Select
AcuLaser C3900 Reference Guide
Network Printing 51