Epson AcuLaser C3900N Reference Manual page 127

Item
Range of IP address
permitted access*
Access Refuse Address
Range of IP address
refused access*
Apply button
Clear button
*
Always enter these addresses without leading zeros. For example, 131.011.010.001 should be entered as 131.11.10.1.
Description
Specify the range of IP addresses permitted access to the printer. Type the IP address at the
beginning of the range into the box on the left, and the IP address at the end of the range
into the box on the right.
Range: 0-255 for each xxx triplet
Default: 0.0.0.0
Note:
❏
To specify a single IP address, type the same IP address into both the box for the
starting IP address and for the ending IP address, or type "0.0.0.0" into the box for
either the starting IP address or the ending IP address.
❏
If the starting IP address is larger than the ending IP address, the setting is not applied.
If Enable is selected, the range of IP addresses refused access to the printer can be
specified.
A maximum of five ranges of refused IP addresses can be specified.
Choices: Enable, Disable
Default: Disable
Configuration Menu Equivalent:
INTERFACE MENU - ETHERNET - TCP/IP - IP ADDRESS FILTER - ACCESS REFUSE
Specify the range of IP addresses refused access to the printer. Type the IP address at the
beginning of the range into the box on the left, and the IP address at the end of the range
into the box on the right.
Range: 0-255 for each xxx triplet
Default: 0.0.0.0
Note:
❏
To specify a single IP address, type the same IP address into both the box for the
starting IP address and for the ending IP address, or type "0.0.0.0" into the box for
either the starting IP address or the ending IP address.
❏
If the starting IP address is larger than the ending IP address, the setting is not applied.
Applies the configuration settings in this page.
Resets all configuration settings to previous values.
AcuLaser C3900
Using Web-Based EpsonNet Config
Reference Guide
127