Error Messages (Warning) - Epson AcuLaser C3900N User Manual

Error Messages (Warning)

This message...
AUTH TIMEOUT
DEVICE
NOT SUPPORTED
FUSER UNIT
END OF LIFE
HDD
NEAR FULL
HUBS
NOT SUPPORTED
INCORRECT
HDD
INCORRECT
P/U X
NONGENUINE
TONER X
P/U END
X
P/U LIFE
X
P/U LOW
X
means...
The user is automatically logged
off due to IEEE802.1X port
authentication.
An incompatible device is
connected.
The fuser unit has reached the
end of its life.
The hard disk is full.
A USB hub is connected.
Since the hard disk drive was
formatted with a different
machine, the hard disk drive
could not be used.
The X photoconductor unit is an
unapproved type.
The installed toner cartridge is
not a genuine Epson product.
The X photoconductor unit has
reached the end of its life.
The X photoconductor unit has
reached the end of its life.
The X photoconductor unit is
nearly empty.
(Appears when SYS DEFAULT
MENU/ENABLE WARNING/P/U
LOW is set to ON.)
AcuLaser C3900 Series
do this...
Reauthorize the IEEE802.1X port, and
then log on.
Do not connect an incompatible
device.
Replace the fuser unit and reset the
counter in the MAINTENANCE MENU/
SUPPLIES/REPLACE/FUSER UNIT
menu.
Note:
Printing can continue, however, the
printing result are not guaranteed.
Delete print jobs saved on the hard
disk.
Do not connect a USB hub.
Replace the hard disk drive with one
compatible with this machine, or
select HDD FORMAT from SYS
DEFAULT MENU and format the hard
disk.
Install a Epson photoconductor unit
of the appropriate type. See
"Replacing a Photoconductor Unit"
on page 87.
Installing a genuine toner cartridge is
recommended.
Replace the photoconductor unit.
Replace the photoconductor unit.
Printing continues until the message
"P/U END" appears.
Prepare the specified color
photoconductor unit.
Troubleshooting
User's Guide
141