Epson AcuLaser C3900N User Manual page 143

This message...
COVER OPEN
SIDE COVER
COVER OPEN
TRAY3 COVER
HOLD JOB ERROR
UNABLE TO
STORE JOB
HOLD JOB ERROR
"OPTIONAL"
PRESS CANCEL
MANUAL EMPTY
"SIZE"
"MEDIA"
MANUAL FEED
"SIZE"
"MEDIA"
MEMORY FULL
PRESS CANCEL
NONGENUINE
TONER X
P/U END
REPLACE
X
P/U MISSING
CHECK X
PAPER EMPTY
"SIZE"
"MEDIA"
means...
The printer's right side cover is
open.
The right side cover of Tray 3 is
open.
The specified print job saved on
the hard disk is sent while the
hard disk is not installed.
When printing a stored job, the
printer configuration was
changed since the job was
stored.
Tray 1 was specified with the
printer driver as Manual Feed for
printing, but Tray 1 is empty.
The Paper Source in the printer
driver is set to Tray 1 (Manual
Feed), but there is already media
in the tray when printing begins.
The printer has received more
data than can be processed with
its internal memory.
The installed toner cartridge is
not a genuine Epson product.
The X photoconductor unit has
completely reached the end of its
life.
The X photoconductor unit is not
installed, or an unapproved
photoconductor unit is installed.
The specified tray is empty.
(Appears when PAPER MENU/
PAPER SOURCE/TRAY CHAINING
is set.)
AcuLaser C3900 Series
do this...
Close the right side cover.
Close the right side cover of the tray.
Print jobs can be saved only if a hard
disk is installed. If desired, install a
hard disk.
Change the printer configuration to
that when the job was stored.
Load the correct media into Tray 1.
Press the key to print, or remove
and reload the media in Tray 1.
Press the Cancel key to cancel the
print job.
Decrease the amount of data to be
printed, and then try printing again.
If that doesn't solve the problem,
install an optional memory module.
Installing a genuine toner cartridge is
recommended.
Replace the photoconductor unit.
Install a correct Epson
photoconductor unit.
Load the correct media into the
specified tray.
Troubleshooting
User's Guide
143