Error / Warning Messages - Epson DFX-9000 Repair Manual

Epson DFX-9000 Field Repair Guide

Error / Warning Messages

The following table is a list of general errors that might be generated by the printer. These errors can be indicated
through beeper sounds, LCD messages, and/or LEDs. This table describes the cause of the errors (Status), and the
appropriate action(s) which should be taken to resolve them.
Beeper sounds
LCD Message
(see below)
Print head hot
Please wait
–
Error:
Switching not
• • •
completed
Error:
No paper
loaded
• • •
Error:
Paper out
• • •
Error:
Ribbon out
• • •
Troubleshooting
Table 1: List of General Errors
LED
Paper Tear Top of
Pause
Out Off Form
Blink - - -
On - - -
On On - -
On On - -
On - - -
Printer Component, Software Item,
Status
Front Rear
- - Head hot warning. The
temperature of the head
thermistor is above the
allowed limit.
- - The printer fails to
completely change the
paper path.
- - Paper out error - loading.
Continuous paper is not fed
to the standby position.
- - Paper out error - No paper
is loaded on the selected
tractor.
- - Ink ribbon out error: The
ribbon is not installed.
LCD Display, Printer Button
3/29/07
Remedy
Wait for the temperature of
the head thermistor to fall
below the upper limit.
Tear off the paper at the
Top Cover, and press the
or
Pause Front/Rear
button.
Tear off the page at the
perforation; then press the
Load button. The
LF/FF
printer feeds the paper to
the standby position.
Load paper on the selected
tractor, or select a different
tractor by pressing the
Front/Rear button.
Remove your paper and
reload it correctly.
Install or reinstall the
ribbon cartridge, and press
the Pause button.
Page 116.