Canon PowerShot SX50 HS User Manual page 253

Invalid selection range
•
When specifying a range for image selection (= 1 76, 181, 187, 241), you
attempted to choose an initial image that was after the final image, or vice-versa.
Exceeded selection limit
• More than 998 images were selected for Print List (= 2 38). Choose 998 images or
less.
• More than 998 images were selected for Print List (= 2 38) or Photobook Set-up
(= 2 43). Choose 998 images or less.
• Print List (= 2 38) or Photobook Set-up (= 2 43) settings could not be saved
correctly. Reduce the number of selected images and try again.
• You attempted to choose more than 500 images in Protect (= 1 75), Erase
(= 1 79), Favorites (= 1 84), My Category (= 1 85), Print List (= 2 38), or
Photobook Set-up (= 2 43).
Communication error
• An excessive amount of images (approx. 1,000) on the memory card prevented
printing or image transfer to a computer. To transfer the images, use a commercially
available USB card reader. To print, insert the memory card directly into the printer
card slot.
Naming error!
•
The folder could not be created or images could not be recorded, because the highest
supported folder number (999) for storing images on the card has been reached and
the highest supported image number (9999) for images in folders has been reached.
In the [3] menu, change [File Numbering] to [Auto Reset] (= 2 05), or format the
memory card (= 2 03).
Lens Error
•
This error may occur if the lens is held while it is moving, or when the camera is used
in dusty or sandy locations.
• Frequent display of this error message may indicate camera damage. In this case,
contact a Canon Customer Support Help Desk.
A camera error was detected (error number)
• If this error message is displayed immediately after a shot, the image may not have
been saved. Switch to Playback mode to check for the image.
• Frequent display of this error message may indicate camera damage. In this case,
write down the error number (Exx) and contact a Canon Customer Support Help
Desk.
File Error
• Correct printing (= 2 31) may not be possible for photos from other cameras or
images that have been altered using computer software, even if the camera is
connected to the printer.
On-Screen Messages
253