Canon PowerShot SX50 HS User Manual page 137

• [Servo AF] (see below) is set to [On] and cannot be changed.
• Tracking may not be possible when subjects are too small or move
too rapidly, or when subject color or brightness matches that of the
background too closely.
• [AF-Point Zoom] on the [4] tab is not available.
• [e] is not available.
• The camera can detect subjects even if you press the shutter button halfway
without pressing the <
center of the screen.
Shooting with Servo AF
This mode helps avoid missing shots of subjects in motion, because the
camera continues to focus on the subject and adjust the exposure as long
as you press the shutter button halfway.
• Focusing may not be possible in some shooting conditions.
•
In low-light conditions, Servo AF may not be activated (AF frames may
not turn blue) when you press the shutter button halfway. In this case, the
focus and exposure are set according to the specified AF frame mode.
• If adequate exposure cannot be obtained, shutter speeds and
aperture values are displayed in orange. Release the shutter
button, and then press it halfway again.
• AF lock shooting is not available.
• [AF-Point Zoom] on the [4] tab is not available.
•
Not available when using the self-timer (= 5 8).
> button. After your shot, [
1
Configure the setting.
z z Press the <n> button, choose
[Servo AF] on the [4] tab, and then
choose [On] (= 4 2).
2
Focus.
z z The focus and exposure are maintained
where the blue AF frame is displayed while
you are pressing the shutter button halfway.
Shooting Range and Focusing
] is displayed in the
Still Images
137