Replacement Of The Lamp - HYOSUNG GV 250 EFI Owner's Manual

WARNING
A hot muffler can burn you. The
muffler will be hot enough to burn
you for some time after stopping
the engine.
Wait until the muffler cools to avoid
burns.
3. Loosen the drive chain adjusters ③ , left
and right, and disengage the drive chain
from the rear sprocket.
4. Remove the rear break hub from the
swing arm.
5. Loosen the rear shock absorber lower
bolts ④ , left and right, draw out the rear
axle ⑤ with the rear wheel push to the
bottom.
6. Pull the rear wheel assembly rearward.
7. To replace the wheel, reverse the
complete sequence listed.
�

REPLACEMENT OF THE LAMP

Requirement electric power of the lamp
shown in the following chart.
When replace the damaged lamp, always
use the equal capacity.
The use of a lamp other than rules may
cause to excessive at the electric system or
to damage the lamp.
NAMES
HI
Head lamp
LO
Position
Brake / Tail lamp
Turn signal lamp
License plate lamp
58
CAPACITY
12V - H4 : 60W× 1
12V - H4 : 55W× 1
12V - W5W× 1
12V - P21 / 5W× 1
12V - RY10W× 4
12V - W5W× 1