Clean Of Battery Terminal - HYOSUNG GV 250 EFI Owner's Manual

CAUTION
● ● Do not remove absolutely airtight
cover as airtight type battery.
● ● Keep after separate at the motorcycle
for the minimum of self electric
discharge and electric leakage when
don't use for a long time.
● ● Remove the ( － － ) negative terminal
when keep intact at the motorcycle.
◉ ◉ CLEAN OF BATTERY TERMINAL
Clean the battery terminal when it is dusty
or rusted.
1. Set the ignition switch "OFF" position.
2. Remove the right frame cover.
3. Check that battery lead wire and
terminal.
4. If necessary : disconnect the negative
( ) battery wire first, then disconnect
the positive ( ) battery wire.
Remove the battery.
5. Clean the terminal.
If there is white dust, clean it with warm
water.
6. Connect the battery wires and grease
the terminal lightly.
When reinstalling the battery, be sure to
connect the positive (
first, then connect the negative (
battery wire.
● ● Keep the battery away from fires.
● ● When disconnecting the battery wire,
● ● Fasten certainly the battery wires.
● ● Incorrect installation of the battery
● ● Never charge a battery while still in
) battery wire
)
42
CAUTION
be sure to remove the negative ( － － )
battery wire first with the ignition
switch "OFF" position, then remove
the positive (＋ ＋ ) battery wire.
When reinstalling the battery, be sure
to connect the positive (＋ ＋ ) battery
wire first, then connect the negative
( － － ) battery wire.
will reverse the terminal position
resulting in possible electrical
system damage due to incorrect
battery lead connection.
the machine as damage may result
to the battery or regulator / rectifier.