Engine Oil And Filter Change; Engine Oil Capacity - HYOSUNG GV 250 EFI Owner's Manual

Table of Contents

Advertisement

CAUTION
Never operate the motorcycle if the
engine oil level is below the "Lower line
mark (L)" in the engine oil level lens.
Never fill the engine oil above the
"Upper line mark (F)". Engine oil level
being most suitable about 1mm under
the "Upper line mark (F)" of the engine
oil level lens. In case of the engine oil
pouring excessively, the engine output
being made insufficient.
Be careful not to pour the engine oil
excessively.
◉ ◉ ENGINE OIL AND FILTER CHANGE
Change the engine oil and filter, after first
running 1,000 km and every running 4,000
km.
The oil should always be changed when
the engine is hot so that the oil will drain
thoroughly from the engine. The procedure
is as follows.

ENGINE OIL CAPACITY

Oil change
Oil and filter change
Engine overhaul
CAUTION
In case of the engine oil pouring
excessively, the engine output being
made insufficient.
Be careful not to pour the engine oil
excessively.
1. Place the motorcycle on the jack or
block.
More frequent servicing may be
performed on motorcycles that are used
under severe conditions, inspect
Quantity of Engine oil,
degree of Engine oil before riding the
motorcycle and then supplement and
replace at any time to prevent damage
of the engine.
2. Remove the engine oil filler cap ① .
3. Drain the oil by removing the drain plug
1,450 ㎖
1,500 ㎖
1,800 ㎖
Necessarily, confirm and clean the oil
strainer
(specially, when first replacement).
26
CAUTION
located on the bottom of the engine.
CAUTION
� �
when replace the Engine oil
① ①
② ②
Pollution

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gv 250 fiAquila 250 fi

Table of Contents