Rear Brake Pedal; Starter Switch - HYOSUNG GV 250 EFI Owner's Manual

⑤ ⑤

STARTER SWITCH

Use this switch to operate the starting
motor.
With the ignition switch in the "ON"
position, the engine stop switch in the
" " position, and the transmission is in
neutral, pull in the clutch lever and side
stand up and push the starter switch to start
the engine.
CAUTION
Do not engage the starting motor for
more than five seconds at a time as it
may overheat the wiring harness and
starting motor.
If the engine does not start after several
attempts, check the fuel supply and
igintion system. (Refer for Page 62)
WARNING
The
the side stand ignition interlock system.
1. If the transmission is in neutral, you
can start the engine regardless of
clutch lever and side stand.
2. If the transmission is not in neutral,
you can only start the engine with
pulling in clutch lever and side stand
up.
Make sure that the side stand igintion
interlock system is working properly
before riding.
is equipped with
21

REAR BRAKE PEDAL

Depressing the rear brake pedal will
apply the rear brake.
The brake lamp will be illuminated when
the rear brake is operated.
WARNING
Apply the brake lightly and with great
care on slippery surfaces to avoid
skidding.