When The Engine Refuses To Start; Trouble Shooting; Ignition System Check; Engine Stalling - HYOSUNG GV 250 EFI Owner's Manual

WHEN THE ENGINE REFUSES
TO START
◉ ◉ TROUBLE SHOOTING
If the engine refuses to start, perform the
following inspections to determine the
cause.
● ● Ignition System Check
①
Remove a spark plug and reattach to the
spark lead.
②
While holding the spark plug firmly
against the crankcase of the engine,
push the starter switch with the ignition
switch in the " ON " position, the engine
stop switch in the "
transmission in neutral, the side stand up
and the clutch disengaged.
If the ignition system is operating
properly, a blue spark should jump a
cross the spark plug gap.
③
If there is no spark, clean the spark plug.
Replace it if necessary. Retry the above
procedure with the cleaned spark plug
or new one.
④
If there is still no spark, consult your
Hyosung dealer for repairs.
WARNING
Performing the spark test improperly
can cause a high voltage electrical
shock or an explosion.
Avoid performing this check if you are
not familiar with this procedure, or if you
have a heart condition or wear a
pacemaker. Keep the spark plug away
from the spark plug hole during this test.
Do not hold the spark plug close to the
open spark plug hole in the cylinder
" position, the
head as gasoline vapor inside the
cylinder should be ignited, creating a fire
hazard.
● ● Engine Stalling
①
②
③
When occur any trouble, the best way is
to consult your Hyosung dealer for
repairs.
WHEN KEEPING FOR LONG PERIOD
1. Supply enough the fuel in the fuel tank.
2. Remove the battery from the motorcycle.
62
WARNING
Check the fuel supply in the fuel tank.
Check the ignition system for intermittent
spark.
Check the engine idle speed.
CAUTION