HYOSUNG GV 250 EFI Owner's Manual page 29

WARNING
New and used oil and solvent can be
hazardous. Children and pets may be
harmed by swallowing new or used
engine oil or solvent. Continuous
contact with used engine oil has been
found to cause skin cancer in laboratory
animals. Brief contact with used oil or
solvent may irritate skin.
● ● Keep new and used oil and solvent
away from children and pets.
● ● Wear a long-sleeve shirt and water-
proof gloves.
● ● Wash with soaf if oil or solvent
contact your skin.
6. Before replacing the engine oil filter
cover, be sure to check that the engine
④
oil filter spring and the "O" ring
installed correctly. Use new "O" ring
each time the engine oil filter element is
replaced.
7. Replace the oil filter cover and tighten
the nuts securely but do not over tighten
them.
8. Replace the drain plug and tighten it
securely. Pour fresh oil through the filler
hole. Approximately 1,500 ㎖
be required.
CAUTION
Approximately 1,450 ㎖ ㎖
required when changing oil only without
replacing the oil filter.
10. Confirm the oil level with the oil level
⑤
are
of oil will
of oil must be
28
CAUTION
In case of the engine oil pouring
excessively, the engine output being
made insufficient.
Be careful not to pour engine oil.
9. Operate the engine a few minutes by
idling speed.
Inspect to leak oil at the oil filter cap.
lens after waiting about a minute next to
stopping the engine.
The oil level is located between the
"Lower line (L)" and the "Upper line (F)".
When below the "Lower line (L)", refill
the oil between the "Lower line (L)" and
the "Upper line (F)".