Inspect every day in the following point at
the brake system.
①
Brake fluid leakage of the front brake
system.
②
Leak or damage of the brake hose.
③
Operating of the brake lever.
④
Wear of the front brake pads.
CAUTION
The brake hoses or the brake fluid of the
front brake system should be replaced
according to periodic inspection chart
by your authorized Hyosung dealer for
safety as in times of operating at high
pressure.
WARNING
Riding with worn brake pads will reduce
braking performance and will increase
your chance of having accident. Inspect
brake pad wear before each use. Ask
your Hyosung dealer or qualified
mechanic to replace brake pads if any
pad is worn to the limit.
CAUTION
After replaced the front brake pads, the
brake lever pull and release several
times so that it is setting at the original
place.
Then, do not ride the motorcycle untill
operating the brake fluid and becoming
the brake distance.
Brake disk inspection
● ●
Check the brake disk for damage or
cracks.
Front brake fluid supply
● ●
1. Place the motorcycle on a level surface
and keep the handlebars straight.
2. Clean the brake fluid reservior around not
to allow dust to get inside of it.
3. Loosen the screw and open the cap.
4. Replenish with brake fluid to the upper
line.
CAUTION
Do not spill any brake fluid on painted or
plastic surfaces as it will damage the
surface severely.
N O T E
The recommended brake fluid
5. Fasten the cap.
● ●
Front brake lamp switch
The front brake lamp switch is located
beneath the front brake lever. Loosen the
switch fitting screws and adjust the timing by
moving the switch body forward or
backward.
52
: DOT3 or DOT4