Drive Chain Cleaning And Oiling - HYOSUNG GV 250 EFI Owner's Manual

20 ~ 30 mm (0.79 ~ 1.18 in)
1. Place the motorcycle on the jack or block.
2. Loosen the axle nut
3. Adjust the slack in the drive chain by
③
adjuster as the lock nut
toward the left and right.
4. For alignment of the rear sprocket and
the front sprocket, there are reference
④
mark on the same position, right and
left.
After aligning and adjusting the slack in
the drive chain to 20 ~ 30 mm (0.79 ~
1.18 in), retighten the axle nut securely
and perform a final inspection.
CAUTION
The drive chain for these motorcycles
are made of the special material.
The chain should be replaced with a
520HO for
Use of another chain may lead to
premature chain failure.
CAUTION
The drive chain should be inspected
every time before riding.
Excessive chain slack could cause the
chain to come off the sprockets and
result in accident or serious engine
damage.
①
.
②
turning
. .
WARNING
Be careful not to touch the muffler when
it is hot : a hot muffler can burn you.
◉ ◉ DRIVE CHAIN CLEANING AND OILING
This drive chain has special "O-rings".
Clean and oil the chain periodically, as
follows :
1. Clean the chain with kerosene. If the
chain tends to rust, the interval must be
shortened. Kerosene is a petroleum
product and will provide some
lubrication as well as cleaning action.
WARNING
Kerosene can be hazardous. Kerosene
is flammable. Children or pets may be
harmed from contact with kerosene.
Keep flames and smoking materials
away from kerosene. Keep children and
pets away from kerosene.
If swallowed, do induce vomiting. Call a
physician immediately.
Dispose of used kerosene properly.
CAUTION
Cleaning the chain with gasoline or
commercial cleaning solvents can
damage "O-rings" and ruin the chain.
Clean the drive chain with kerosene
only.
49